Since the PC will try to obtain its address on the interface from the RNDIS adapter "set_dhcp_s enable" can be used to enable a DHCP server on the interface.Ĭhange the MAC address (sometimes 00-00-00-00-00-00 is not accepted) to anything else, like "MAC 00-00-00-00-00-01" This will cause it to automatically reset and save but you can save at any time with "save" and change various other network settings as desired. With "show_config" the default settings can be seen, which will be ![]() Show_config_w Show working network config. Show_config Show configured network config. Hit enter to connect and then 'N' plus ENTER to move into the network menu, which looks like this: The network first needs to be configured though by using the the VCOM port on the debugger (LPUART on the i.MX RT t 115200 Baud): This allows any USB processor to function as a network to a PC without needing it to do a USB-Ethernet adapter function. Just connect the USB device connector to a PC and install the RNDIS driver as described in the installation section of (assuming you are on Windows). (it may work by dragging and dropping it onto the debug USB/MSD disk too). ![]() To load it to the board the NXP MCUBootUtility can be used as described in the section 4 of Please find attached an RNDIS device reference for the MIMXRT1060EVK.
0 Comments
Leave a Reply. |